Spray Gun - Vevor Rf6000Ag Bedienungsanleitung

WARNING
--TURN OFF AIR AND COATING MATERIALS TO THE GUN AND RELEASE
PRESSURE BY TRIGGERING THE GUN BEFORE DISASSEMBLINGM,
CLEANING OR SERVICING.
--PAY ATTENTION WHEN DISASSEMBLING SPRAY GUN SINCE YOU MUST
TOUCH SHARP PARTS.
--DO NOT DISASSEMBLE WITHOUT RECEVING ENOUGH KNOWLEDGE
AND EDUCATION.

SPRAY GUN

1. Submerge the front end of the gun in solvent just until the fluid connection is
covered.
2. Paint that has built up on the gun should be removed using a bristle brush and
solvent.
3. Never submerge all of the spray gun in solvent because:
• This will dissolve the lubricant in the packings and on wear surfaces, causing
them to dry out and resulting in difficult operation and faster wear.
• Air passages in the gun will become clogged with dirty solvent.
4. Using a rag moistened with solvent, wipe down the outside
of the gun.
5. Oil gun daily. Use a drop of lightweight machine oil on:
A. fluid needle packing
B. air valve packing
C. trigger pivot point See Fig. 1 for Location of above points.
6. NOTE: Do not soak rubber o-rings or seals in paint thinner.
O-rings and seals can be wiped clean with paint thinner but
soaking can cause these items to deteriorate over time.
7. Caution: Do not use lubricants which contain silicone.
Silicone may cause defects in the finish application.
CLEANING AND MAINTENANCE
- 14 -