Cleaning And Maintenance; Spray Gun - Vevor W-2000B5 Bedienungsanleitung

CLEANING AND MAINTENANCE

SPRAY GUN

1. Submerge the front end of the gun in solvent just until the fluid connection is
covered.
2. Paint that has built up on the gun should be removed using a bristle brush and
solvent.
3. Never submerge all of the spray gun in solvent because:
• This will dissolve the lubricant in the packings and on wear surfaces, causing
them to dry out and resulting in difficult operation and faster wear.
• Air passages in the gun will become clogged with dirty solvent.
4. Using a rag moistened with solvent, wipe down the outside of the gun.
5. Oil gun daily. Use a drop of lightweight machine oil on:
A. fluid needle packing
B. air valve packing
C. trigger pivot point See Fig. 1 for Location of above points.
6. NOTE: Do not soak rubber o-rings or seals in paint thinner.
O-rings and seals can be wiped clean with paint thinner but
soaking can cause these items to deteriorate over time.
7. Caution: Do not use lubricants which contain silicone.
Silicone may cause defects in the finish application.
- 9 -