Drilling And Screwing - Meister AS108VLM Originalbetriebsanleitung

5401060-Akkubohrsc_man 04.02.15 09:26 Seite 49
In daily use
In order to protect the rechargeable
battery: Recharge the battery before it is
completely discharged.
Figure 5-2: Check the battery charge
state:
LED LED
Red Yellow Green
Figure 5-4: Take the rechargeable
battery out of the handle of the cordless
drill-screwdriver.
Figure 5-1: Charge the rechargeable
battery.
Figure 5-3: When the rechargeable
battery has been charged, insert as far
as it will go into the handle of the
cordless drill-screwdriver.
The cordless drill-screwdriver is ready
for operation.
8 – Drilling and screwing
Insert the drill bit or screwdriver blade
CAUTION! Driven moving parts.
Risk of injury if switched on
unintentionally. Separate the device
from the power supply.
Figure 5-4: Take the rechargeable
battery out of the handle of the cordless
drill-screwdriver.
LED Charge state
Almost empty
Half-full
Full
Figure 6-1: Hold the locking collar (1)
firmly and open the chuck (2). Insert the
drill bit or screwdriver blade. Hold the
locking collar (1) firmly and close the
chuck (2).
Ensure that the jaws in the chuck grasp
the tool and centre it.
Select the direction of rotation
Figure 6-2: Select the required
direction of rotation. To drill: Always
clockwise.
Set the torque limiter
The torque limiter is an adjustable friction
clutch. When screwing, it prevents the
screw heads from penetrating too far into
the work piece.
Figure 6-3: Set the torque limiter:
For screwing screws into soft
work pieces
to
For screwing screws into
hard work pieces
For drilling (without torque
limiter)
Select the revolution range
Figure 6-4: Select the revolution range:
First gear (low revolutions):
0...350/min
Second gear (high
revolutions): 0...1,000/min
49