Components; Correct Use - Meister AS108VLM Originalbetriebsanleitung

5401060-Akkubohrsc_man 04.02.15 09:26 Seite 42
Noise emission/vibration
Sound level
Sound power level
Vibrations when drilling
Vibrations when screwing 0,34 m/s
Measuring inaccuracy K: 1,5 m/s
The measured vibration values were
determined in accordance with
EN 60 745-2-1, EN 60 745-2-2,
EN 60 745-1.
Information about minimising vibrations
Information:
• The specified vibration emission value
was measured in accordance with a
normed test procedure and can be
used in order to compare one power
tool with another.
• The specified vibration emission value
can also be used for an introductory
evaluation of the exposure.
Warning:
• The vibration emission value may
fluctuate from the specified value
during actual use of the power tool.
These fluctuations will depend on the
way in which the power tool is used.
• If your hands experience an unpleasant
sensation or the skin changes colour
while you are using the machine,
immediately interrupt your work. Take
sufficient breaks. If you do not take
sufficient breaks, this may cause a
hand/arm vibration syndrome.
• Evaluate the level of load according
to the work or the use of the tool and
42
take sufficient breaks. This method
L = 73 dB(A)
pA
K = 3 dB
pA
L = 84 dB(A) Information about minimising noise
wA
K = 3 dB
wA
2
1,49 m/s A certain amount of noise is
2
unavoidable when using this device.
2
Ensure you carry out noise-intensive
work during permitted times. Maintain
the quiet periods and limit your work to
the absolute minimum. For the sake of
your personal protection and the
protection of persons in the vicinity,
suitable ear defenders should be worn.
3 – Components
1
2
3
4
5
6
7
8
9
10
4 – Correct use
Drilling in wood and metal, screw-
driving. Employ the machine, charging
unit and accessories (follow
manufacturer's directives!) for specified
area of application only! All other
applications are explicitly excluded.
This unit may not be used by people
(including children) with reduced
physical, sensory or mental capacities,
with a lack of experience and without
the appropriate knowledge, unless they
are supervised by someone who is
responsible for their safety or have been
can be used to considerably minimise
the level of load during the entire
working time.
Chuck
Locking collar
Torque limiter
Revolution range switch
Ventilation slots
Rotation direction switch
On/Off switch with revolution
regulator
Handle
Rechargeable battery
LED light