Operation; A) Starting Dcf Reception Attempt Manually; Setting Date And Time - Renkforce Smart USB Bedienungsanleitung

9. Operation

a) Starting DCF Reception Attempt Manually

This is only possible if no Smartphone is connected for charging
via the USB charging port (9).
• Push the button "°C/°F WAVE" (14) for 3 seconds to restart the DCF
reception attempt.
A flashing radio tower symbol above the seconds indicates the search
for the DCF signal.
" " Good reception of the DCF signal
" " No reception
• The DCF signal search will take several minutes. Do not move the
projection clock during this time and do not push any button.
Do not put the projection station next to electronic devices,
metal parts, cables, etc. Bad reception can also be expected,
e.g. in case of metallised insulation glass windows, reinforced
concrete construction, coated special wallpaper or basement
rooms.
b) Setting Date and Time
To change a setting, use the buttons "+" (11) and "-" (12). Keep
the respective button pressed for quick adjustment.
If you do not push any button for about 30 seconds during set-
ting, the settings made until then are saved automatically and
setting mode is left.
Proceed as follows:
• Briefly push the button "MODE" (13) repeatedly until the display on the
right shows the indoor temperature.
• To start setting, keep the button "MODE" (13) pushed for approx. 3
seconds.
The year will start to flash in the display (in the display "YR"); set it with
the buttons "+" 11) and "-" (12).
• Briefly push the "MODE" button (13). The month ("MONTH") flashes. Set
it with the buttons "+" (11) and "-" (12).
37