H) Dual Time; Displaying Dual Time; Setting Dual Time - Renkforce Smart Usb Bedienungsanleitung

• To terminate the alarm signal (or snooze mode), push the button "
(15).
The alarm signal is automatically terminated after 4 minutes if
no button is pushed.

h) Dual Time

The projection clock can show a second time (dual time) in the right area
of the display instead of the alarm time as well.

Displaying Dual Time

Repeatedly press the button "MODE" (13) briefly until "DT" is displayed at
the right side of the display. The second time is then displayed.

Setting Dual Time

• Repeatedly press the button "MODE" (13) briefly until "DT" and the second
time is displayed at the right side of the display.
• Hold down the "MODE" button (13) for about three seconds until the
dual time hours flash in the display.
• Set the dual time hours with the buttons "+" (11) and "-" (12). Keep the
respective button pressed for quick adjustment.
• Briefly push the "MODE" button (A). The minutes of the dual time flash.
Set them with the buttons "+" (11) and "-" (12). Keep the respective button
pressed for quick adjustment.
• Briefly push the button "MODE" (13) to leave setting mode.
"
41