Setting Alarm Time; Switch Alarm Function On/Off; Activate Snooze Mode Or End Alarm Signal - Renkforce Smart USB Bedienungsanleitung

Set Alarm Time
• Push the button "MODE" (13) several times until either the alarm time
1 (display "AL1" at the right in the display) or the alarm time 2 (display
"AL2") is displayed.
• Hold down the "MODE" button (13) for about three seconds until the
alarm time hours flash in the display.
• Set the alarm time hours with the buttons "+" (11) and "-" (12). Keep the
respective button pressed for quick adjustment.
• Briefly push the "MODE" button (A). The minutes of the alarm time flash.
Set them with the buttons "+" (11) and "-" (12). Keep the respective button
pressed for quick adjustment.
• Briefly push the button "MODE" (13) to leave setting mode. The currently
set alarm time is activated automatically.
The corresponding icon appears in the display above the alarm time:
" " = Alarm function is switched on with alarm time 1
" " = Alarm function is switched on with alarm time 2

Switch Alarm Function On/Off

Repeatedly press the button "
the desired alarm function. The respective symbol appears above the
alarm time:
• Symbol "
• Symbol "
• Symbols "
times
• No display = Alarm function off

Activate Snooze Mode or End Alarm Signal

• The alarm signal is activated at the set alarm time and the bell symbol
" " (for alarm time 1) or "
• By touching the sensor surface "SNOOZE" (2) on the front of the projec-
tion clock, the alarm signal is interrupted for the duration of 4 minutes
(snooze mode), and the display lighting is activated for a few seconds.
During this time, the corresponding bell symbol continues to flash.
After the end of 4 minutes, the alarm signal will be restarted. This
procedure can be repeated several times.
40
" = Alarm function is switched on with alarm time 1
" = Alarm function is switched on with alarm time 2
" and " " = Alarm function is switched on with both alarm
" (15) briefly to activate or deactivate
" (for alarm time 2) flashes.