Contrôle De Continuité - VOLTCRAFT VC-100 Bedienungsanleitung

e) Mesure de courant continu
Attention !
Les mesures de courant doivent être effectuées dans les systèmes uni-
quement à une tension max. de 250V!
Ne reliez jamais les câbles de mesure en parallèle aux composants con-
ducteurs lorsque le réglage est sur „Mesure de courant"!
• Courants continus inférieurs à 200mA
Mettez le sélecteur rotatif sur la plage de mesure de courant
de 200mA.
Raccordez le câble de mesure noir à la prise „COM", le rouge
à la prise „VΩmA".
Reliez les câbles de mesures aux points de mesure en série.
• Courants continus supérieurs à 200mA
Mettez le sélecteur rotatif sur la plage de mesure de courant
„10A ".
Raccordez le câble de mesure noir à la prise „COM", le rouge
à la prise „10A".
Reliez les câbles de mesures aux points de mesure en série.
f) Contrôle de continuité
Placez le sélecteur rotatif sur „ ".
Raccordez le câble de mesure noir à la prise „COM", le rouge à la prise „VΩmA".
Reliez les câbles de mesures aux points de mesure. Un bip sonore retentit lorsque l´objet testé
a une continuité.
42
If you exceed the max. value under unfavourable conditions the risk of dama-
ging the measuring instrument and danger to life increases.
This device is not a toy and should be kept out of the reach of children!
In commercial institutions, the accident prevention regulations of the Employ-
er's Liability Insurance Association for Electrical Systems and Operating Mate-
rials are to be observed.
In schools, training centres, computer and self-help workshops, handling of
electrical appliances must be carried out or supervised by qualified and res-
ponsible personnel.
Please make sure before measuring, that the insulation of the measuring lines
does not show any damages. Examin the measuring accurancy by trying a mea-
suring at a well-known voltage.
If you have reason to assume that safe operation is no longer possible, dis-
connect the device immediately and secure it against inadvertent operation.
It must be assumed that the safe operation is no longer possible, if:
- The device shows signs of visible damage,
- the device no longer functions
- the fuse of the appliance is defective
- the device has been stored under unfavourable conditions for a longer period
of time
- the device has been subjected to unsuitable conditions of transport
- the insulation of the device is damaged.
Repair works may only be carried out by a specialist resp. a specialist work-
shop.
If you have queries about handling the measuring device, that are not answered
in this operating instruction, our technical support is available under the follo-
wing address and telephone number:
Voltcraft®, 92242 Hirschau, Lindenweg 15, phone 0180 / 586 582 723 8
23