Waeco MagicSpeed Accessory Montage- Und Bedienungsanleitung Seite 16

MS-be4 24/06/03
Diagnostic mode B
When test A has been successfully completed, proceed to test B. You can check the
function of the actuator with this diagnostic mode. Move the manual gearshift into neutral
or the automatic gearshift into park, then apply the hand brake. Start the engine with the
SET button depressed. Release the SET button when the engine is running. Then switch
on cruise control with the ON/OFF button. The LED in the control unit lights up. Press the
SET button and keep it pressed down. The engine speed must slowly rise (warning: do
not allow the engine to overspeed). Press the RES button and keep it pressed down. The
engine speed should slowly decrease. The engine speed should decrease again to a
neutral speed position by applying the brake or clutch or activating the ON/OFF switch.
Switch off the ignition when leaving the diagnostic mode.
Diagnostic mode C
The diagnostic mode C is used to check the cruise signal or speed signal. Start the
engine with the SET button depressed. Release the SET button when the engine is
running. Drive the vehicle at a speed of approx. 50 km/h. Switch on cruise control with
the On/Off-button in the control unit. The LED in the control unit should now flash approx.
once per second and you should receive an acoustic signal approx. once per second.
Activate the adjustment- and training program if it is not already activated. When the ve-
hicle stops, switch off the ignition to leave diagnostic mode.
Note The diagnostic modes are used to check all components and func-
tions of cruise control. Cruise control uses an internally created reference
signal to test the actuator in diagnostic mode B. If cruise control does not
work correctly after successful completion of TEST B, then the problem is
usually the pickup of the cruise signal.
15:24 Page 16
Diagnostic mode
16 16