Using The Appliance; Emptying The Dust Canister - Mpm Mod-34 Bedienungsanleitung

EN
2. Insert the EPA filter (7) into the dust canister and secure: align the three bosses on the filter
with the three slots within the dust canister and rotate the filter clockwise until locked.
3. Insert the filter cage (8)into the dust canister and secure: align the three bosses on the filter
cage with the three slots within the dust canister and rotate the filter cage clockwise until
locked.
4. Close the hinged cover (5) to lock.
5. The removal of the filter and its cage is done by releasing both with a counter-clockwise rota-
tion and reversing the assembly procedure.
6. Attach the telescopic wand (12) to the wand port (9) and the tool you require (13), (14)or (15).

USING THE APPLIANCE

1. Make sure that the vacuum cleaner has been properly assembled and with filters in place.
2. Choose the best tool for vacuum cleaning the specific surface. Optimum vacuum cleaning
efficiency is achieved by using the tools as follows:
- Hard floor & carpet tool (13): use it to clean carpets, rugs, and hard floors (like tiles or terrazzo).
- Slot tool (15): use it to clean narrow spaces.
- Small multifunctional brush (14): use it to clean curtains, upholstery, clothing, furniture or
window blinds.
3. Plug the power cord into a mains outlet and start the vacuum cleaner with the power switch (2).
CAUTION! This appliance is intended for cleaning of dry surfaces only!
4. Monitor the dust canister (4) level. When it is full, stop vacu-
um cleaning and empty the dust canister. Working with the
dust canister overfilled reduces the vacuum cleaner's perfor-
mance (the centrifugal force, which expels dust dirt into the
duct canister, is reduced) and the filters become clogged too
fast.
5. If the suction power drops noticeably during vacuum cleaning
and the dust canister is empty, immediately check the wand
and the attached tool for obstruction.
6. You can also attach the tools directly to the motor unit's
mouth. This makes the vacuum cleaner more compact to
clean places which are hard to reach
7. When done, turn off the vacuum cleaner with the power
switch (2) and unplug the power cord from the mains.

EMPTYING THE DUST CANISTER

1. Turn off the vacuum cleaner with the power switch (2) and
unplug the power cord from the mains.
2. Hold the motor unit (1) with the dust canister (4) directly
above the trash can
3. Press the hinged cover release (6) to swing open the cover (5) ,
then shake out all dust.
4. Close and lock the hinged cover (5) .
26
Fig. 1
.
Fig. 2
.
Fig. 1
Fig. 2