Werbung
Verfügbare Sprachen
Verfügbare Sprachen
STATIC ELECTRICITY
Vacuum cleaning certain surfaces at a low air humidity may cause slight electrification of the
appliance. This is natural, does not damage the appliance and does not constitute its defect.
To minimise this phenomenon, it is recommended to:
frequently discharge the appliance by touching items in the room with the metal pipe,
increase air humidity in the room,
use generally available anti-electrostatic products.
APPLIANCE ASSEMBLY
1. Remove the vacuum cleaner from the box and discard all bags, stickers and fillers.
2. Check that the dust canister and all filters are properly installed in place. See the installation
and removal instructions in Sections: "EMPTYING THE DUST CONTAINER" and "AIR FILTER
CLEANING AND REPLACEMENT".
3. Attach suction hose ⑩ to the socket ⑮ - lock it by slightly rotating the hose end until the
locking mechanism engages. Mount the appropriate equipment on the other end of the suc-
tion hose, as required - telescopic tube ⑭ and/or appropriate brush ⑯, ⑰, ⑱. The length
of the telescopic tube can be adjusted by pressing the button on the tube and extending/
retracting the tube according to the user's needs.
USING THE APPLIANCE
1. Before turning on the vacuum cleaner, unwind the power cord ⑬ to a suitable length and
plug it into a mains outlet. The yellow mark on the power cord indicates the optimum length
limit. Do not pull out the power cord beyond the red mark! Do not press the vacuum cleaner
power cord winder button.
2. Press the power switch ③ to turn on the vacuum cleaner.
3. Monitor the dust canister level. Do not overfill the dust canister. Otherwise the suction power
will be reduced and the filters will become dirty prematurely.
CAUTION! If you feel a rapid drop of the suction power, empty the dust canister and/or unclog the suction hose.
4. To optimally position the appliance after use, place the parking guide in the horizontal posi-
tion located between the protective grille buttons ② and ③. Place the rail at the back of the
floor-carpet head with the connected suction hose and telescopic tube on the rail.
5. To retract the power cord, press the button ② with one hand and hold the cord with the
other hand to prevent sudden shuffling that could damage the cord.
ACCESSORIES OVERVIEW
FLOOR-CARPET ATTACHMENT
Designed for cleaning large flat surfaces. It is equipped with castors that facilitate movement
in difficult to access places and a flexible joint, connecting it with the suction hose, which
allows directing at various angles. When you press the button on the upper attachment ho-
using (switch it to the brush mode), a row of rigid bristles will appear on the bottom to facili-
tate cleaning hard floors.
14
Werbung
