VEVOR RD-10 Bedienungsanleitung Seite 9

Before using the tool, check whether the state of the worksite is as follows;
is the worksite free of foreign objects, debris, water, ice, snow, powered
electrical cables, and excessive dust? Is the floor free of obstructions? Is
there adequate ventilation? Is the worker properly insulated from the
ground. Follow the operation instructions and avoid prohibited items.
Remove Hazardous Substances
Since the tool is an electric tool, it may spark and cause an explosion or a
fire if operated near gas cylinders, thinner, or explosive and other
hazardous substances or in a place filled with flammable gas, etc.
Therefore, do not use the tool in places where such hazardous substances
are present.
DANGER: May cause an explosion or a fire. Ignoring this
warning may cause death or serious injury. Never use the tool in places
filled with flammable gas or near hazardous substances of high
flammability.
Maintenance of the Main Unit
Always unplug the saw from the electric outlet before attempting any
maintenance. Clean the entire unit occasionally by removing dust, debris
and oils. Occasionally remove the flush cutting bottom plate; then remove
any cutting chips that remain lodged in the area where the cutting blade
rotates.
It is also recommended that the cutting blade be removed and inspect for
any materials that did not exit out the chip exhaust area. This should be
done after 4-8 hours of use. Most material cutting chips would normally exit
out the chip exhaust area and into the Cutting Chip Catch Bag. It is
recommended that the Cutting Chip Catch bag be emptied when it
becomes 2/3 full of cut material.
- 8 -