VEVOR RD-10 Bedienungsanleitung Seite 8

DANGER: The Cutting Edge Saw is not a waterproof power
tool. If it becomes wet, the power source system may become faulty or the
operator may get an electric shock. Therefore, when it is raining or snowing,
never operate this saw outdoors, on top of buildings or under roofs where
rain or snow enters freely. Do not use where water accumulates or where
water splashes.
Operation Instructions
Adjust the rear handle position to comfortably grip the tool. (The rear
handle changes position with the button located on the top of the handle.)
Locate the front handle in the mounting hole that provides the best grip. To
operate the trigger, depress the trigger lock button (on the side of the tool)
and then pull the trigger to start the saw. Start the saw before cutting and
then apply a light pressure moving forward through the cut.
DANGER: Electric Shock Hazard.Ignoring this warning may
lead to death or serious injury. When raining or snowing, do not operate
outdoors or indoors where rain or snow enters freely or in extreme
temperatures.
Do not use under high temperature and humidity or extremely cold
temperature conditions. The tool is designed for use under an allowable
environmental temperature of 0 to 100°F. Operation at higher temperature
may cause the tool's main unit to overheat. Operation at high temperature
with high humidity may cause the tool to fail due to condensation.
Also, do not operate the Cutting Edge Saw in very cold places or inside
refrigerators where the temperature is freezing or below.
Check The State of Your Work Site
- 7 -