VEVOR RD-10 Bedienungsanleitung Seite 10

CE-25 Blade
The Blade for the CE-25 Cutting Edge Saw should be replaced when the
blade is dull or chipped and a noticeable increase in cutting time has
occurred.
To change the Blade, remove the screws that hold the Blade Cover to the
Body (4). Remove the cover and unscrew the (4) bolts holding the blade to
the Hub. The replacement blades that you purchase have new screws to
be used when installing the new blade. Make sure that when you remove
the blade you clean out the head of any metal debris that has not escaped
the tool.
Please see your distributor for more information.
General Operating Cautions
The following describe the general cautions on operating tool. Always
observe the cautions stated in each item.
•Do not press the operation switch if the tool is pointed towards anyone.
Operating the tool by holding it toward anyone may cause injury from
contact with the blade.
•Do not apply the Cutting Edge Saw for purposes it is not intended.
•Do not use the tool for lifting or hammering etc. instead, only use this tool
for cutting. Otherwise, the main unit may be broken or damaged, causing
injury.
- 9 -