Ruris RX 655 Handbuch Seite 54

Use clean, fresh, unleaded gasoline.
Do not mix oil with gasoline.
Check the fuel level.
Before refueling, allow the engine to cool for 2 min., clean around the filler hole before
removing the tank cap.
Problems Cause
○ Knife handle stop is disconnected
The engine
○ Spark plug disconnected
does not start
○ Throttle cable misaligned
○ The tank is empty or the fuel is out
of date
○ Gasoline valve blocked
○ Defective spark plug or spark plug
○ Drowned engine
○ The machine moves to the starting
The engine
runs with position
speed
○ Interrupted ignition
fluctuations
○ Gasoline valve blocked or old fuel
○ Water or dirt in the fuel
○ Clogged air filter
○ Carburetor out of order
○ Engine oil below level
Overheated
○ Low air circulation
engine
○ Carburetor not properly adjusted
○ Clogged carburetor
Interruptions
○ Defective spark plug
in engine
○ Defective spark plug or cable
speed at high
speeds
○ Loose cutter or unbalanced
Excessive
vibration machine
○ Engine speed too low
The machine
does not cut
○ Wet lawn
the lawn
○ Grass too tall
10. PROBLEM GUIDE
EN
means
○ Tighten the knife stop handle
○ Connect the spark plug
○ Check the cable source
○ Fill the tank or change the fuel
○ Clean the fuel valve
○ Clean the holes or change the
plug or spark plug
○ Ventilate the combustion
chamber
○ Shift the gear lever to fast
○ Connect and tighten the spark
plug plug
○ Clean the valve and fill the tank
with fuel
○ Empty the tank and replace the
fuel
○ Clean the air filter or replace it
○ Adjust the carburetor
○ Change the oil or top up
○ Clean the cooling spaces
○ Adjust the carburetor
○ Clean the carburetor
○ Replace the spark plug
○ Replace the plug or ignition
○ Tighten the blade to the adapter
○ Check the blade balance
○ Change the blade
○ Adjust carburetor or governor
levers (service).
○ Do not mow the lawn when it is
wet, wait until it dries.
○ Cut once to high height then cut
25