Ruris RX555S Handbuch Seite 52

Do not overfill the oil sump. If you put above the maximum level the following effects may
occur:
1. Fumigation
2. Rough start,
3. Clogging of the spark plug,
4. Oil can get into the air filter.
Fuel recommendations:
Use clean, fresh, unleaded gasoline.
Do not mix oil with gasoline.
Check the fuel level.
Before refueling, let the engine cool for 2 min., clean around the filler hole before
removing the tank cap.
Problems Cause
The engine ○ Knife handle stop is disconnected
does not start ○ Spark plug disconnected
○ Throttle cable misaligned
○ The tank is empty or the fuel is out
of date
○ Gasoline valve blocked
○ Defective spark plug or spark plug
○ Drowned engine
The engine ○ The machine moves to the starting
runs with position
speed
fluctuations ○ Interrupted ignition
○ Gasoline valve blocked or old fuel
○ Water or dirt in the fuel
○ Clogged air filter
○ Carburetor out of order
Overheated ○ Engine oil below level
engine ○ Low air circulation
○ Carburetor not properly adjusted
Interruptions ○ Clogged carburetor
in engine ○ Defective spark plug
speed at high ○ Defective spark plug or cable
speeds
Excessive ○ Loose cutter or unbalanced machine
vibration
24
10. PROBLEM GUIDE
EN
means
○ Tighten the knife stop handle
○ Connect the spark plug
○ Check the cable source
○ Fill the tank or change the fuel
○ Clean the fuel valve
○ Clean the holes or change the plug
or spark plug
○ Ventilate the combustion chamber
○ Change the gear lever to fast (fast)
○ Connect and tighten the spark plug
plug
○ Clean the valve and fill the tank with
fuel
○ Empty the tank and replace the fuel
○ Clean the air filter or replace it.
○ Adjust the carburetor
○ Change the oil or top up
○ Clean the cooling spaces
○ Adjust the carburetor
○ Clean the carburetor
○ Replace the spark plug
○ Replace the plug or ignition
○ Tighten the blade to the adapter
○ Check the blade balance
○ Change the blade.