Turn On The Camera - Num'axes Protection Pie1075 Gebrauchsanleitung

When inserting the batteries, make sure to follow polarities indicated inside the
battery slot. Upside down batteries may cause device malfunction.
NOTE: Don't mix battery types! This may cause permanent damage not covered
by the guarantee.
Remove the batteries from the camera if you are not using it for 3 months or
more. The batteries could leak and damage your product.
This camera can also be powered by an external power supply 6V/1.5A.
4. Installing the memory card
The camera doesn't have an internal memory. Using a memory card is required
to operate the camera (micro SD card from 8GB up to 256GB maximum – class
10 minimum). You can purchase micro-SD cards at any time at
www.numaxes.com.
Before inserting or removing the memory card, the camera must be turned off
(switch in the OFF position). Failing to do so may cause loss of or damage the
files already recorded on the card.
5. Operation
5.1.

Turn ON the camera

Put the switch in the M1, M2 or M3 position; the camera is ready to work.
Once in the M1, M2 or M3 mode, the camera will take photos and/or videos
M1 – Mode 1 – Photos | M2 – Mode 2 – Videos | M3 – Mode 3 – Photos + Videos
5.2. Turn OFF the camera
Slide the switch to the OFF position to turn off the camera.
Please note that even in OFF mode, the camera still consumes power at a very
low level. Therefore, please remove the batteries if the camera will not be used
for a long time period.
The OFF mode is the "safe mode" for actions such as replacing the memory card
and batteries or transporting the camera.
FGIMPGUI362 – Guide PIE1075 – Mars 2025 – ind. A - 14/72