Num'axes PROTECTION PIE1075 Gebrauchsanleitung Seite 15

5.3. Upload photos/videos saved on memory card
To upload photos/videos on a computer, connect the supplied USB cable to the
camera's USB Type-C port and then directly to a main USB port on your
computer.
WARNING: Do not disconnect the USB cable or remove the memory card while
copying photos/videos. You could lose files.
Alternatively, you can remove the memory card from the camera and use a
micro-SD card reader.
Before removing the memory card, the camera must be turned off (switch in
the OFF position). Failing to do so may cause loss of or damage the files already
recorded on the card.
6. Setting up the camera
− Mount the camera facing north or south, not east or west as the rising and
setting of the sun could produce false triggers and overexposed images.
− If you're covering a trail, face the camera down or up the trail.
− Clear out any brush or weeds in front of the camera. These can cause false
triggers due to temperature and motions disturbances in front of the
camera (especially in windy days).
− Check the power level of the batteries.
− Make sure the memory card is properly inserted and have sufficient
available space.
− Make sure to turn the camera on (switch in the M1, M2 or M3 position).
7. Technical specifications
Image sensor
Infrared flash
FGIMPGUI362 – Guide PIE1075 – Mars 2025 – ind. A - 15/72
2 Mega Pixels Colour CMOS
2 invisible high intensity IR LED
Wavelength: 940 nm
IR flash range: approx. 20 m (65.6 ft.)