Turn On The Camera - Num'axes PIE1066 Gebrauchsanleitung

You can purchase micro-SD cards at any time at www.numaxes.com.
Before inserting or removing the memory card, the camera must be turned off
(switch in the OFF position). Failing to do so may cause loss of or damage the files
already recorded on the card.
Formatting the memory card in the trail camera before using it for the first time is
strongly recommended, especially when the card has been used in other devices. A
memory card formatted in another device may not be compatible.
In ON mode, if no memory card is inserted, the LDC screen displays "No memory
card".
When the memory card is full, the LCD screen indicates "Memory full".
5. Operation
5.1.

Turn ON the camera

You can switch on the camera any time after the batteries and memory card have
been inserted. Put the switch in the ON position; the camera is ready to work.
The red start-up indicator light located on the front cover will blink and the LCD
display will count down 15 seconds. This interval allows you time to close the camera
front cover and leave the monitored area.
Once in the ON mode, the camera will take photos and/or videos according to its
current parameter settings.
NOTE: the camera comes pre-programmed with factory default settings. So, for test
purpose, you only need to insert the memory card and AA batteries then power on
the camera (switch in the ON position).
5.2. Turn OFF the camera
Slide the switch to the OFF position to turn off the camera. Please note that even in
OFF mode, the camera still consumes power at a very low level. Therefore, please
remove the batteries if the camera will not be used for a long time period.
The OFF mode is the "safe mode" for actions such as: replacing the memory card or
batteries, or transporting the camera.
5.3. Customizing the operating settings
To enter the camera setting menu, slide the switch to the ON position (the LCD screen
will light up) then long press the UP/MENU button.
Guide PIE1066 – Mars 2023 – ind. A - 22/78