Cleaning The Charging Base; Cleaning The Self-Check And Calibration Surfaces - Loop Clk01 Gebrauchsanweisung

5.4 CLEANING THE CHARGING BASE

Clean every few weeks or as needed. Carefully clean with the following method:
1. Temporarily disconnect the charging base from the power supply cord.
2. For cleaning, refer to Section 5.2 "Cleaning After Use."
3. Make sure that the charging pins and surrounding area are completely dry when finished. You may use
compressed air or gentle use of a dry soft cloth. Take care to not bend the charging pins when drying.
4. Reconnect the power supply cord to the charging base.
5.5 CLEANING THE SELF-CHECK & CALIBRATION SURFACES
On the charging base, there are two calibration surfaces that should be cleaned. Clean once per year or if having
problems with Calibration.
Black surface used for Self-Check Dirty Lens Detection: Clean the Self-Check Dirty Lens Detection surface with
air blow-off only. Use sufficiently to remove all dust and debris. In most cases, nothing more will be required to
keep the black surface functional. In cases of severe contamination, the use of a mild surface cleaner like Sparkle
or Windex may be gently applied via a cotton swab if followed with a gentle rinse of distilled water and dried with
™
clean compressed air.
White surface used for Calibration: Cleaning of the white calibration surface is rarely needed due to its protected
location, but the process requires more care:
1. Carefully clean the white surface with the supplied Loop
then proceed to the next step.
2. Do not use sprays or cleaners other than what is prescribed. Gently wipe with gauze or a towelette saturated with
Sparkle or Isopropyl Alcohol. Wipe in a gentle circular motion.
™
3. Repeat the above step using distilled water.
4. Blow off with compressed air and allow 5 minutes additional dry time. Surface is now ready for use.
lens cleaning cloth. If this does not fully clean the surface,
™
22
™