Power Supply And Adapters; Charging And Batteries - Loop Clk01 Gebrauchsanweisung

4.9 POWER SUPPLY AND ADAPTERS

The Loop power supply is a 1.5m universal-input unit that accepts 100-240VAC nominal (50-60Hz).
™
WARNING: The Charging Base must only be used with the power supply provided for the Loop
charging base and connected with the appropriate supplied power adapter. Attempting to use
another power supply may create a risk of electric shock to the operator or damage the product and will void
the warranty.
The power supply is preloaded with the 120V US – Type A adapter. Select the appropriate adapter for your region.
Power Supply and Adapters instructions:
1. Select the proper adapter for your region. Retain unused adapters for future use. The applications are as follows:
• 120V US — Type A
• Euro —Type C
• UK — Type G
• Australian — Type I
2. Insert the tip of the blade assembly into the power supply at a 30-60 degree angle (Fig. 1). The top edge of the
blade assembly is flat and the bottom edge is U shaped. The power supply has the corresponding shapes.
3. Push the blade assembly into the power supply in a downward motion (Fig. 2).
4. Push the blade assembly down until the blade assembly locks in place. A clicking sound will occur (Fig. 3).
5. To check the AC Blade assembly for correct insertion, hold the power supply in one hand. Using another hand, pull
up on the blade (Fig. 4).
Fig. 1
Removing the AC Blade assembly:
1. Using thumb or finger, slide the spring loaded locking key downward. It is marked with an arrow (Fig. 5).
2. Holding the locking pin down, pull upward on the AC blade to remove (Fig. 6).
Fig. 5

4.10 CHARGING AND BATTERIES

Loop LED curing light system has been designed to have the handpiece placed in the charging base after each use
™
and cleaning. The charging base's smart charging circuitry removes any concerns regarding over-charging. When
the handpiece is left inactive and disconnected from a charging base, it will power down and draw an insignificant
amount of energy from the battery. Batteries will last longest in this condition when more than 50% charged.
Loop contains a powerful lithium-ion rechargeable battery. The lithium ion battery is designed to provide two to five
™
years of use depending on frequency and severity of use.
• Battery pack life: 300 full charge/recharge cycles
• Output: 3.7 Volts nominal @ 2.5A-H capacity
CAUTION: The battery pack contains a Lithium ion (Li-ion) battery. Recycle or dispose of batteries
according to national, state and local regulations.
Fig. 2
Fig. 6
Fig. 3
NOTE: The blade assembly is "finger proof"
which meets regulatory requirements against
shock hazards
19
Fig. 4
™