Protective Light Shield - Loop Clk01 Gebrauchsanweisung

Protective barrier sleeve is turned ON.
Protective barrier sleeve is turned OFF.
CAUTION: Ensure the barrier sleeve is snug fitting and lays flat against the lens.
CAUTION: Using a brand of barrier sleeve other than Loop
functioning properly and an accurate output power cannot be ensured.
CAUTION: Not using a Loop
contamination on the lens from skin oils or debris. Do not touch the lens to skin or other surfaces.
Keep lens clean.
If not using a Barrier Sleeve, follow these steps:
1. In Settings, make sure that the Barrier Sleeve is set to OFF. Refer to Section 4.3 "Settings".
2. Clean Loop ensuring the lens surface is clean. Refer to Section 5 for "Maintenance and Cleaning."
™
3. Use Loop as normally directed. Refer to Section 4.0 "Operation".
™

4.8 PROTECTIVE LIGHT SHIELD

Using a light shield protects the operator's eyes when viewing light output through the shield. The Loop
light shield can be rotated for maximum efficacy. The shield can be used with or without a protective barrier sleeve.
To use the Protective Light Shield (Fig. 1), snap on the protective light shield avoiding the rotation joint. (Fig. 2)
Fig. 1
barrier sleeve may reduce the accuracy of Auto-Start due to
™
Fig. 2
18
may prevent the handpiece from
™
protective
™