In The Event Of A Malfunction - Hamma Misceo 3 Anleitung

In the event of malfunctions
DO NOT OPEN THE DEVICE: WARRANTY LOSS!
- For a reliable and sustainable maintenance or repair, you can send the Misceo 3 to the manufacturer, who
will provide special service offers for your Misceo 3.
-> See also under "Update, maintenance and service offers"
Mixture of the mixed cooling lubricant is not correct
- Viscosity input does not agree with the medium, viscosity specification depends on temperature
-> Adjust the Misceo to your cooling lubricant via the "Adjust" menu item in the main menu
- During startup or when cooling lubricant changed there are still air bubbles in the concentrate hose
-> Corrects itself through constant mixing
- The concentrate should have reached room temperature (min. 15 ° C)
Misceo 3 indicates lack of water
- Please check the supply line for kinks/bends.
- Please check whether the water tap has been opened which is connected to the Misceo 3.
- Please check whether the filter seal at the
water inlet is clean (see service instructions).
Misceo 3 indicates lack of concentrate
- The concentrate should have reached room temperature (min. 15 ° C)
- Please check the connection of the
- Please check the concentrate supply line for kinks/bends.
- Please check whether the supply line reaches the cooling lubricant concentrate.
- Please check whether there is still cooling lubricant available.
- Please verify that the foot valve of
- Water flow rate too low (flow rate min. 600l/h)
- Viscosity is incorrect.
- Please check whether the filter seal for the concentrate
(installed in the Misceo) is clean (see service instructions)
Misceo 3 has no power
- Please check whether the plug-in power supply is plugged in.
- Please have your electrician check the mains socket.
- If the error cannot be fixed by pressing the "Enter" key, a factor overhaul is required.
Error message at start: "Service"
- Water in the device. Factory overhaul required (see service instructions)
Error message "Mixture outside of tolerance
- Viscosity is not correct, adjust viscosity via "Adjust"
- Reset pressure maximizer, keep the up arrow key and plus key pressed, add flow, wait two seconds and
release keys again. Reset is carried out. (See service instructions)
Service instructions of the Misceo 3
If you would like to do maintenance or small repairs on your Misceo 3 yourself, you can request the service
instructions at the e-mail add
repairs.
Pressure control message "Filling level reached" is shown and hidden many times consecutively
The inlet water volume is higher than the output water volume, which causes backpressure in the outlet line
-> Enlarge the output line cross section or throttle the water supply until there is a visible reduction in the
water volume on the display and the Misceo mixes properly. Recommended inlet line 1/2", recommended
outlet line 3/4".
If an error message appears, please remedy the error according to menu guidance. In the event
of serious errors (factory overhaul required), please send the Misceo 3 back to the manufacturer
for repairs.
For more information, see the website www.hamma-uwt.de in the service area.
Concentrate suction hose of
Concentrate suction hose
ress info@hamma-uwt.de.
tightness
present, clean and functional
Here, there are helpful tips for maintenance and small
23 ENG