Function - Hamma Misceo 3 Anleitung

Function

After connecting the plug-in power supply to the voltage supply, the Misceo 3 electronics are activated. An
introduction runs on the display, the self-diagnostics routine runs and the user-friendly menu is displayed. The
viscosity is to be set (in mm²/s 20°C - DIN 51562) and the language selected in the main menu. With "Enter"
on "Next" to get to the filling menu for concentrate. After filling the concentrate, you will reach the filling
menu for water. Once you have finished filling the Misceo 3, you can enter your mixing data in the mixing
menu and begin the mixing operation with "Enter" on "Start". During the mixing operation, the concentrate
and water detection is active and the Misceo interrupts the mixing operation if either run low. The Misceo 3
now mixes the cooling lubricant according to your inputs. If you should discover a deviation in the
concentration after measuring your mixed cooling lubricant, adjust the Misceo 3 via the menu item "Adjust" in
the main menu (observe the refractometer value). Once the Misceo 3 has finished the mixing operation, you
can choose whether you want to mix again, go to the main menu or relieve the pressure to safely disconnect
the Misceo 3 from your water line. Once you have relieved the pressure from the Misceo 3, you can unplug
the plug-in power supply from the socket. Your Misceo 3 is properly shut down and waits for its next use.
Attention: When filling and relieving the pressure, hold the outlet hose into a collection container, since fluid
can be ejected. The discharge hose must have free run and not be closed by a ball valve or otherwise.
Important input functions are supported by the red and green LEDs located above the "Enter"
key. If the red LED is illuminated, an action is expected. If the green LED is illuminated,
everything is OK and can continue.
Flow diagram
3
1
MIKRO
300
4
2
Flow diagram
1 Process water
2 Cooling lubricant concentrate
3 Power supply
4 Cooling lubricant
7 ENG