Create FIRE ROUND HEATER Bedienungsanleitung Seite 9

Note:
• Confirm that the control knob is in the "OFF" position.
• Open the gas control valve on the cylinder. Check for leaks by running a soapy solution through all joints in the gas system,
including all valve connections, hose connections, and regulator connections.
• Never use an open flame to check for leaks.
• If bubbles form in any of the reservoirs, there is a leak. If the connection is not sealed, immediately close the bottle valve and
tighten the connection or replace the problem part. Repeat the leak test annually and whenever you repair or replace the
gas cylinder.
R E M OVE TH E CYL IN D E R
1. Replacement should always be done in safe places and in the absence of flames or ignition sources. When the appliance is
in operation, never attempt to disconnect the regulator from the gas cylinder.
2. The regulator is designed so that it cannot be removed from the cylinder when the gas is on. Therefore, you should check
that the device key is in the "locked" position. And the gas supply is in the locked position.
3. Remove the regulator by pulling the ring vertically. Always check that the regulator connection is in good condition. Store
the regulator with the gas hose under the grill. Make sure the hose is not twisted or kinked in any way.
4. Store the gas cylinder properly in a safe place.
• Fit the gas cylinder valve with the cap nut and safety cap.
• Do not store the gas cylinder in areas below ground level, or in stairs, hallways or areas where pedestrians or vehicles pass
through.
• Always store the gas cylinder outside.
• Always place the cylinder in an upright position even when empty.
E NGL ISH 9