How To Use - Mova Rle22Ga Benutzerhandbuch

How to Use

EN
Press and hold the button for 3 seconds to turn on the robot. The power
indicator should be illuminated. Place the robot onto the charging dock, the
move the robot away from the dock and press and hold the button for 5
seconds.
Fast Mapping
After configuring the network for the first time, follow the instructions in the
app to quickly create a map. The robot will start mapping without cleaning.
When the robot returns to the charging dock, the mapping process has been
completed and the map will be saved automatically.
Start Cleaning
Press the button to start cleaning after the robot is turned on. Then, the
robot will methodically clean each room in an S-shaped pattern, then finish
by cleaning along the edges and walls to ensure a thorough job.
Note: It is recommended that the robot set out from the charging dock before
cleaning. Do not move the charging dock while the robot is cleaning.
This ensures that the robot returns to charging dock smoothly.
Pause
When the robot is running, press any button to pause it.
Note: If the robot is paused and placed onto the charging dock, the current
cleaning task will end.
12
Auto Resume Cleaning
If the battery is too low, the robot will automatically return to the charging
dock to charge. After charging to the appropriate battery level, it will resume
unfinished cleaning tasks.
Note: To use this function, please enable it in the app.
Do Not Disturb (DND) Mode
When the robot is set to Do Not Disturb (DND) mode, the robot will be
mode is disabled by default at the factory. You can use the app to enable DND
mode or modify the DND period. The DND period is 22:00–8:00 by default.
Note:
· The scheduled cleaning tasks will be performed as usual during the DND
period.
Spot Cleaning
When the robot is on standby, press and hold the button for 3 seconds
to enable the spot cleaning mode. In this mode, the robot cleans a square-
shaped area of 1.5 × 1.5 meters around it and returns to charge once the spot
cleaning is completed.
Robot Restarting
button for 3 seconds to turn the robot on.
How to Use
Use Mopping Function
1. Fill the water tank with clean water.
Note: Do not use detergent or disinfectant.
2. Dampen the mop pad and wring out excess water. Install the mop pad as
shown in the diagram.
1 2 3
3. Install mop assembly.
4. Slide the 2-in-1 water tank with dust box and mop assembly into the robot
until it clicks into place.
EN
13