Mova RLE22GA Benutzerhandbuch Seite 3

Safety Information
EN
Usage Restrictions
To prevent damage or harm from dragging, clear any loose objects from
the floor, and remove cables or power cords on the cleaning path before
operating the appliance.
Keep hair, fingers, and other body parts away from the suction opening of the
robot.
Do not place children, pets, or any item on top of the robot regardless of
whether it is stationary or moving.
Do not use the robot to clean any burning objects. Do not use the robot to pick
up flammable or combustible liquids, corrosive gases, or undiluted acids or
solvents.
Do not vacuum hard or sharp objects. Do not use the appliance to pick up
objects such as stones, large pieces of paper or any item that may clog the
appliance.
Make sure the robot is turned o and the charging dock is unplugged before
cleaning or performing maintenance.
Do not use a wet cloth to wipe or any liquid to rinse the robot and charging
dock. Washable parts must be dried completely before installing and using
them.
Make sure the robot is turned o when being transported and kept in its
original packaging if possible.
Please use this product in accordance with the instructions in the User Manual.
Users are responsible for any loss or damage that arise from improper use of
this product.
2
Safety Information
Batteries and Do not use any third-party battery, charger, or charging dock. Use only with
Charging
RCEA0102 supply unit.
Do not attempt to disassemble, repair, or modify the battery or charging dock
on your own.
Do not place the charging dock near a heat source.
Do not use a wet cloth or wet hands to wipe or clean the dock's charging
contacts.
Do not improperly dispose of old batteries. Unneeded batteries should be
discarded at an appropriate recycling facility.
If the robot will not be used for an extended period, fully charge it, then turn
it o and store in a cool, dry place. Recharge the robot at least once every 3
months to avoid over-discharging the battery.
This product contains batteries that can only be replaced by qualified
technicians or after-sales service.
Laser Safety The invisible laser sensor in this product meets the IEC 60825-1:2014,
Information
EN 60825-1:2014+A11:2021, EN 50689:2021 Standard for Class 1 laser
products. Please avoid direct eye contact with it during use.
CLASS 1 LASER PRODUCT
CONSUMER LASER PRODUCT
EN 50689:2021
EN
Max output: <0.39 mW
Wavelength: 840-860 nm
Pulse duration: 0.125 ms
3