Mova RLE22GA Benutzerhandbuch Seite 11

Routine Maintenance
EN
Clean the Mop Pad
1. Press the release clips on the mop pad holder to remove the mop assembly.
Pull the mop pad o the mop pad holder.
2. Clean the mop pad with water only and leave it to air dry before
reinstalling.
Battery
The robot contains a high-performance lithium-ion battery pack. Make sure
that the battery remains well-charged for daily use to maintain optimal
battery performance. If the robot is not used for an extended period of time,
the robot at least once every three months.
18
Clean Robot Sensors and Charging Contacts
Wipe sensors and charging contacts of the robot by using a soft and dry
cloth, as shown in the below figure:
Note: A wet cloth can damage sensitive elements within the robot and the
charging dock. Please use a dry cloth for cleaning.
LDS Cover
Laser Distance
Sensor (LDS)
Bumper
Return-to-Dock
Sensors
Charging Contact Charging Contact
Charging Contacts
Troubleshooting
Problem
The battery level is low. Recharge the robot on the charging dock, then try again.
Robot does not turn on. The temperature of the battery is too low or too high. It is recommended to operate the appliance at a temperature
between 32 °F (0°C) and 104 °F (40°C).
The charging dock is not receiving power. Please confirm that both ends of the charger are plugged in correctly.
Robot does not recharge.
Poor contact. Clean charging contacts of the charging dock and robot.
Robot does not return to There are too many obstructions around the charging dock. Place the charging dock in a more open area.
charging dock. Please clean the dock's signaling area.
Robot is malfunctioning.
Robot is making a strange A foreign object may be caught in the main brush, side brush, or one of the main wheels. Stop the robot and remove any
noise. debris.
Robot no longer cleans The dust box is full. Please clean it.
The filter is blocked. Please clean it.
behind. A foreign object is caught in the main brush. Please clean it.
Solution
EN
19