Before Use - Mova Rle22Ga Benutzerhandbuch

Before Use

EN
1. Remove the protections
2. Install the side brush and the mop assembly
Click
Note: Install the side brush until it clicks into place.
10
3. Place the charging dock on level ground against
the wall and connect it to a power outlet
Place the charging dock in a location that is as open as possible with a good
Wi-Fi signal.
Note:
Do not place the charging dock on the carpets.
Remove any objects that are closer than 1.5 m from the front and 0.5 m
from either side of the charging dock.
Do not place the charging dock in an area with direct sunlight or where
other objects might block the signal, as this may hinder the robot from
returning to the charging dock.
4. Charge the robot
When placing the robot, align the charging contacts at the bottom of the robot
with the charging contacts of the charging dock, and the robot will automatically
turn on and start charging.
Note: It is recommended to fully charge your robot before first time use.
Connecting with the MOVAhome App
1. Download the App
Scan the QR code on the robot to download and install the app.
QR code
Note:
Only 2.4 GHz Wi-Fi is supported.
Due to upgrades in the app software, the actual operations may di er from
the directions in this manual. Please follow the instructions based on the
current app version.
2. Add the Device
Open the app, tap "Scan QR code to connect", and scan the same
QR code on the robot again to add the device. Please follow the prompts
to finish the Wi-Fi connection.
Note: If you want to reset Wi-Fi, press and hold the and button for
3 seconds or repeat step 2 and then follow the prompts to finish the Wi-Fi
connection.
QR code
EN
11