Herunterladen Diese Seite drucken

Silvercrest SZPH 130 B1 Bedienungs- Und Sicherheitshinweise Seite 18

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
Do not exert too much pressure
on the juicing cone .
Make sure that there are no
 
foreign objects in the sieve or
the product when operating it .
To avoid damaging the product,
 
stop the juicing process
immediately if the juicing cone
does not spin easily or does not
spin at all . Unplug the mains
cord and check whether there
are foreign objects inside the
product .
The product is equipped
 
with anti‑slip rubber feet . As
furniture surfaces are coated
with a variety of varnishes
and materials and treated
with different care products, it
cannot be ruled out that some
of these substances may contain
chemicals that will corrode
and soften the rubber feet . If
necessary, place an anti‑slip
layer under the product .
Place the product on a stable,
 
level surface .
Never place the product on
 
hot surfaces (i .e . hobs) or near
sources of heat or open fires .
Clean the product after use (see
 
"Cleaning and care") .
Do not clean the base unit in
 
the dishwasher or using boiling
water .
Do not use harsh or abrasive
 
cleaning agents .
FOOD SAFE! This product
has no adverse effect on
taste or smell .
˜ Before first use
˜ Preparing the product for use
1 . Rinse the removable parts before the first use .
2 . Use the cable winder 
of the mains cord 
12 ]
[
fix this into the intended groove on the bottom
of the product (Fig . B) .
3 . Insert the drive shaft 
bracket 
.
[
8 ]
4 . Attach the juice holder 
juicing cone 
to the drive shaft 
[
1 ]
5 . Plug the mains plug 
˜ Preparing citrus fruits
The product is made so that citrus fruits (e .g . limes,
lemons, oranges) can be appropriately squeezed
based on their size .
For an optimal juice yield, use the ripest fruits
possible, which contain more juice .
Cut the citrus fruits in half across the fruit
o
segments, so that you get an upper and a
lower half and all fruit segments are cut .
˜ OFF mode
The product enters OFF mode when plugged in
o
without pressing on the juicing cone 
The product leaves OFF mode when you pull
o
the handle 
down and press on the juicing
[
5 ]
cone 
so that the juicing cone starts rotating .
[
1 ]
˜ Initial use
m
WARNING! Make sure that there are no
foreign objects in the sieve 
when operating it .
to wind up the length
[
10 ]
that is not required and
into the drive shaft
7 ]
[
, sieve 
and
3 ]
[
2 ]
[
.
7 ]
[
into a socket outlet .
[
12 ]
.
1 ]
[
or the product
[
2 ]
GB/IE
19

Werbung

loading

Diese Anleitung auch für:

474710 2407