Scheppach 5906707901 Originalbetriebsanleitung Seite 32

16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Diamond cutting wheel is loose
after the motor is switched off.
Motor does not start
The motor has no power
32 | GB
Possible cause
Fixing nut not tight enough
Mains fuse blown
Extension cable defective
Connection to the motor or
switch not OK
Motor or switch faulty
Cross section of the extension
cable insufficient
Overload
www.scheppach.com
Remedy
Tighten fixing nut
Check mains fuse
Replace extension lead
Have this checked by an electrician
Have this checked by an electrician
See Electrical connection, the fuse
responds
Check tool