LAVAZZA A MODO MIO DESEA Bedienungsanleitung Seite 87

Press the FREE DOSE button
cycle.
If the FREE DOSE button
within 9 minutes after the acoustic signal, the ma-
chine switches off automatically and you should re-
peat the step of the procedure to start the cycle.
In case of power supply interruption, the machine
will, upon the first power-on, resume the descaling
procedure where it was interrupted: press the FREE
DOSE button to restart DESCALING.
The machine will automatically activate the descaling
process, after the heating cycle is over.
During the descaling cycle, the FREE DOSE button
will be ON and blinking and the descaling warning lamp
will be ON to a steady light
During the descaling cycle, the machine will auto-
matically perform intermittent supply cycles, to allow
the container to be emptied.
The descaling cycle can be temporarily interrupted by
pressing either the FREE DOSE
To start the cycle again, press the FREE DOSE button
.
The cycle will be temporarily interrupted when the fluid
runs out in the machine tank.
DO NOT top up the tank during this phase.
You must allow the tank to empty completely.
MAINTENANCE AND CLEANING
to start the descaling
button is not pressed
or button.
Empty the container used to collect the solution.
The button, FREE DOSE button
warning lamp
warning lamp
Remove the water tank, rinse and wash it accurately. Fill
it with drinking fresh non-carbonated water up to the
MAX. level.
In case of power supply interruption, the machine will,
upon the first power-on, resume the rinse procedure
where it was interrupted: press the FREE DOSE but-
ton to restart RINSING.
Fit the tank back into place on the machine. Place a con-
tainer with a capacity of at least 16.9 fl oz (0.5 L) under the
supplying device.
Press the FREE DOSE button
cycle.
To end the rinse cycle, a minimum amount of water of
33.81 fl oz (1 litre) (approximately 1 full tank)
to be supplied.
In case of lack of water, the cycle will be temporarily interrupt-
ed, the machine will emit a prolonged acoustic signal
enabled) and the "No water" warning lamp
a steady light. Top up the tank and press the FREE DOSE
button
again to restart the rinse cycle.
At rinse end, the descaling warning lamp goes off, which
confirms that the procedure has come to an end.
Before using the machine, empty and thoroughly rinse
the milk frothing jug and its cover, clean the machine
using a soft moist cloth.
87
and "No water"
will be ON to a steady light. Descaling
will be ON and blinking.
to start he rinsing
will come on to
E N
will have
(if