LAVAZZA A MODO MIO DESEA Bedienungsanleitung Seite 67

COFFEE DOSE PROGRAMMING
Measures are always programmed using the same but-
ton; any action by pressing other buttons will be ignored.
The programmed amount of brewed coffee can be
changed by repeating the programming.
It is not possible to program the coffee dose in milk-
based beverages.
Press the button to switch the machine on.
The machine will be ready when the button
blinking and the supply button lights are steadily.
Lift the pod loading lever until it locks into position to
open the pod fitting compartment.
Put a Lavazza
fitting compartment.
Lower the pod loading lever to close the pod fitting
compartment. Place the cup onto the plate.
PROGRAMMING
stops
capsule into the capsule
Press down the button of the icon you wish to program.
The machine will start supplying and, after approximate-
ly 3 seconds, the other coffee buttons will start blinking
and the machine will beep
gramming mode has been accessed.
Keep the supply button depressed
Once the desired amount of coffee has been obtained,
stop supply by releasing the button.
The machine will stop and the dose will be programmed
If the programmed measure exceeds the maximum al-
lowed the machine will automatically stop delivery, the de-
livery button will blink and the last programmed measure
will be saved in the memory.
If there is a power failure during programming, the last
programmed value remains in the memory.
If during a dose programming, water lack
the machine stops the supply and the dose being pro-
grammed won't be saved. Once filled the water tank, re-
peat the dose programming procedure.
67
E N
, to indicate that the pro-
is indicated,