Parkside Performance 448848 2304 Originalbetriebsanleitung Seite 38

Always hold the product firmly with
two hands while working. Ensure that
your stance is secure and stable .
For an optimum grinding effect, move the
product evenly at an angle of 30° to 40°
(between grinding disc and workpiece) back-
wards and forwards .
When working on angled surfaces,
do not exert great force on the
workpiece. If the rotational speed drops
significantly, you must reduce the pressure
exerted to allow safe and effective working .
If the product suddenly brakes completely or
jams, it must be switched off immediately .
Cutting: Work at a moderate feed
rate and do not tilt the cutting disc.
Grinding and cutting discs become
very hot – let them cool down
completely before touching them.
Never use the product for purposes
other than the ones for which it was
designed.
Always make sure that the product is
turned off before plugging it into the
power socket.
In case of danger, remove the plug
from the power socket immediately.
Ensure that the product and the power socket
are easily and quickly accessible in the event
of an emergency .
Always remove the plug from the
power socket during work breaks,
when adjusting the product and when
it is no longer in use. The product must be
kept clean, dry and free of oil and grease at
all times .
Remain alert at all times! Always pay
attention to what you are doing and
act with common sense. Do not use the
product if you are distracted or feeling unwell .
m
WARNING!
Wear safety glasses and a dust mask!
˜ Use
˜ Adjusting/removing the
grinding guard
Fig . B, C
m
WARNING! RISK OF INJURY!
Switch off the product and disconnect
it from the mains before making any
adjustments, performing maintenance,
cleaning and when the product is not
in use .
m
WARNING! RISK OF INJURY!
u
Always use the angle grinder with
the grinding guard
guard should be fitted securely . Set it so
that the highest possible degree of safety is
achieved, i .e . the smallest possible part of
the grinding disc or cutting disc is open to
the operator . The grinding guard is designed
to protect the operator from fragments and
accidental contact with the grinding tool .
u
Make sure that the grinding guard
is fitted at least at the same angle as the
additional handle
you could cut injure yourself on the grinding
disc or cutting disc .
NOTE
u
The grinding guard
product .
o Adjusting the grinding guard
grinding guard to the desired angle .
Removing the grinding guard
o
– Unscrew the 3 screws under the backing
[ 14 ]
flange (Fig . C) .
– Remove the grinding guard .
9 ] [
. The grinding
[ 9 ]
[ 7 ]
(Fig . B) . Otherwise,
[ 9 ]
is pre-installed on the
[ 9 ]
: Rotate the
9 ] [
:
GB/IE 37