Parkside Performance 448848 2304 Originalbetriebsanleitung Seite 41

˜ Setting the rotational speed
Adjust the rotational speed via the rotational
o
speed control panel
– Level 1: lowest speed level
– Level 6: highest speed level
Increase the rotational speed: Press the
o
rotational speed control button +
o Decrease the rotational speed: Press the
rotational speed control button –
o Carry out practice tests to determine the
required speed level .
˜ Connecting/disconnecting the
detachable mains cord
Fig . G
m
CAUTION! RISK OF INJURY!
u
Always unplug the mains plug
the mains socket before connecting or
disconnecting the detachable mains cord to
or from the product .
NOTE
u
Rotate the coupler
4 ] [
mains cord to lock or unlock the
connection .
J
Connecting the mains cord
3 ] [
1 . Insert the coupler
5 ] [
main handle until it stops .
3 ] [
2 . Rotate the coupler
the connection .
3 . Pull the mains cord
rotation to check if the coupler
installed .
40 GB/IE
1 ] [
:
[ 1b ]
.
[ 1b ]
.
4 ] [
from
[ 3 ]
of the detachable
into the socket at the
to the position to lock
4 ] [
lightly without any
[ 3 ]
is securely
Disconnecting the mains cord
3 ] [
1 . Rotate the coupler
unlock the connection .
2 . Disconnect the coupler
[ 5 ]
the main handle
˜ Maintenance and cleaning
m
WARNING! RISK OF INJURY!
Switch off the product and disconnect
it from the mains before making any
adjustments, performing maintenance,
cleaning and when the product is not
in use .
NOTE
u
Replacement parts not listed (such as carbon
brushes) can be ordered via our service
hotline (see „Service") .
Do not use any sharp objects to clean the
product . Never permit liquids to enter inside
the product . Otherwise the product could be
damaged .
The carbon brushes should only be replaced
by the service centre or an authorised specialist
workshop .
Apart from this, the product is maintenance-
free .
If the mains cord is damaged, it must be
replaced by a special mains cord that is
available from the manufacturer or its service
agent:
– VDE plug: 99944884706
– BS plug: 99944884702
o Clean the product regularly, preferably
immediately after completion of the work .
o Clean the housing with a dry cloth . Do not use
petrol, solvents or cleaners which can attack
the plastic .
A vacuum cleaner is required for thorough
o
cleaning of the product .
Ventilation openings must never be obstructed .
o
to the position to
3 ] [
from the socket at
.