elero RolTop/D+ Nutzungsinformation Seite 16

Assembly: Electrical connection | Programming the end positions
2 Disconnect the plug.
3 Insert connector until the latch engages.
Removal and insertion of the device plug
Delivery status
Fig. 4 Removal and insertion of the device plug
5.3 Connection example RolTop/D+
230V / 50Hz
junction box
1 0 2
power grid
230V/50Hz
PE
N
L
Fig. 5 Circuit diagram RolTop/D+ 230 V / 50 Hz and
wiring with delivery with Hirschmann plug STAS 3
Important
The motor control must be interlocked in up / down direction.
5.4 Parallel connection
Important
scatola di
You can connect several parallel RolTop/D+. Note the maxi-
derivatione
mum switching capacity of switching.
5.5 Commissioning
1 0 2
Important
The drive is in the delivery in commissioning mode.
rete
230V/50Hz
5.5.1 Automatic programming of end limits
PE
N
►The programming is done in the light of the end posi-
L
tions in Chapter 4 (product description) described pre-
requisites normally automatic (self-learning, without elero
cable assembly).
Program end positions automatically
1 Connecting the electrical system in accordance with
Chapter 5.2.
Check operation: If necessary, replace or modify
2
map the directional controls of the operation switch /
tasters.
6 | EN
Remove plug Insert plug
3
1
2
M
1~
1 0 2
3 3
2 2
1 1
M
1~
1 0 2
Program end positions automatically
The drive switches off when reaching the (upper or lower)
end stop automatically.
The teaching is completed by further movements of the
blinds.
5.5.2 Manual setting of the end positions
►The connection of the elero cable assembly is only per-
mitted for manual operation of the drive and delete the
end positions.
Blue (neutral conductor)
(2)
Black
Fig. 6 Connection for cable assembly
(3)
Brown
Green-yellow
Program end positions manually
Press the [UP ▲] button.
1
Move to the upper stop.
The drive switches off when reaching the end stop auto-
matically.
Press the [DOWN ▼] button till the shutter is shut
2
down up to 30 cm.
Repeat 2 more times, start of the upper stop (as
3
described in (1)).
Press the [DOWN ▼] button.
4
Proceed to the lower stop.
The drive switches off when reaching the end stop auto-
matically.
5 Press the [UP ▲] button until the roller shutter is
ascended about 30 cm.
6 Repeat 2 more times, start of the lower stop (as
described in (4)).
The programming of the end positions is completed.
After successful drive assembly the drive must be driven al-
together 3 times into the upper end position and 3 times into
the lower end position. The drive must stop automatically.
5.5.3 Changing / deleting the limit positions and
deleting the discharge function
A change or deletion of a single end position is not possible.
This is always done in pairs (upper and lower end position
simultaneously).
By the deletion of the end positions and the adjustment of
the optional discharge function is lost.
Changing / Deleting the end positions
Connect the drive to the cable assembly and switch
1
on the power supply.
Adjust the shutter with the cable assembly in a cen-
2
tral position.
3 Simultaneously press both the [UP ▲] and the
[DOWN ▼] buttons at the installation cables.
The drive runs up and down briefly.
© elero GmbH
(1)