Publishing Notes - Hauff-Technik Fubo Rb150 Montageanleitung

Pipe elbow with installation fixture
FUBO RB
2 ENPipe elbow wit h inst allat ion f ixtur e
Table of Contents
1

Publishing Notes ........................................................ 8

2 Explanation of Symbols ............................................. 8
3 Description ................................................................ 8
4 Prepare for assembly ................................................. 8
5 Installation of the pipe elbow .................................... 8
6 Variants ..................................................................... 9
1 Publishing Notes
Copyright © 2025 by
Hauff-Technik GmbH & Co. KG
Department: Technical Editing
Robert-Bosch-Straße 9
89568 Hermaringen, GERMANY
Tel. +49 7322 1333-0
Fax +49 7322 1333-999
E-mail office@hauff-technik.de
Internet www.hauff-technik.de
Reproduction of this Assembly instructions – even in
extracts – in the form of reprint, photocopy, on electronic
data media or using any other method requires our
written consent.
All rights reserved.
Subject to technical alterations at any time and without
prior announcement.
These installation instructions form part of the product.
Printed in the Federal Republic of Germany.
2 Explanation of Symbols
1 Work stages
► Effect/result of a work step
Reference numerals in drawings

3 Description
Description: RB200 pipe elbow with installation fixture
(see Fig.: 1).
Key to Fig.: 1
1 Pipe bend
2 Three-ribbed seal
3 RB150 pipe elbow recess
4 RB200 pipe elbow recess
5 Styrodur installation fixture
8
4 Prepare for assembly
1 For accurate positioning of the pipe elbows, a batter
board must be prepared on site (see Fig.: 2).
The line ideally identifies both the upper edge
of the unfinished floor, as well as the wall
inside surface.
5 Installation of the pipe elbow
1 Lift the pipe elbow slightly, pass it through the
appropriate recess in the installation fixture (see Fig.:
3).
2 Position the pipe elbow with the installation fixture
on a level trench floor and align all axes of the pipe
elbow with a spirit level (see Fig.: 4).
3 Fit the sealing cap and fix it with adhesive tape if
necessary (see Fig.: 5).
4 Support the pipe elbow together with the installation
fixture with sand to stabilize it (see Fig.: 5).
The pipe elbow can additionally be secured
and stabilized using an on-site fixing device
(e.g. reinforcement bar). The sealing area
around the 3-ribbed seal must be kept clear!
5 Position the 3-ribbed seal centrally on the pipe elbow
within the area of the concrete slab (see Fig. 7).
6 Set the pipe elbow in concrete (see Fig.: 8).
Legend of Fig.: 6
1 Section can be shortened
2 Unfinished floor
3 3-ribbed seal
• The system allows the pipe elbow to be
• Check all measurements to ensure the
• A suitable press seal (available separately)
Legend of Fig.: 7
OKFF Upper edge of finished floor
OKRF Upper edge of unfinished floor height
Art. Nr.: 3030609552 Rev.: 00/2025-03-20
shortened at any time according to the
future floor construction/finished floor
level.
distance from the wall is maintained.
Recommended distance from wall: at least
50 mm (see Fig.: 9).
must be used to seal the media line in the
pipe elbow!
EN