Cameo AZOR SP2 IP Bedienungsanleitung Seite 26

1. Housing surfaces must be cleaned with a clean, damp cloth. Make sure that no moisture can
penetrate the device.
2. Air inlets and outlets must be regularly cleaned of dust and dirt. If compressed air is used, make
sure that damage to the device is prevented (for example, fans must be blocked in this case, as
they could otherwise over-rev).
3. Cables and connectors must be cleaned regularly, and dust and dirt must be removed.
4. In general, no cleaning agents or abrasive agents may be used; otherwise, the surface finish
may be damaged.
5. Devices must be stored in a dry environment and protected from dust and dirt.
6. To ensure correct and safe operation, all accessible or removable lenses and light-emitting
apertures must be cleaned regularly.
MAINTENANCE AND REPAIR (by qualified personnel only)
DANGER! There are live components in the device. Even after disconnecting from
the mains, there may still be residual voltage in the device, for example, due to
charged capacitors.
PLEASE NOTE! Maintenance and repair work may only be carried out by sufficiently
qualified personnel. If in doubt, consult a specialist workshop.
PLEASE NOTE! Improperly performed maintenance work may affect warranty claims.
PLEASE NOTE! For conversion or retrofit sets provided by the manufacturer, it is
essential to observe the enclosed installation instructions.
REPLACING GOBOS
ATTENTION: Gobos may only be replaced by qualified personnel. If you are not
qualified to do this, do not try to replace gobos yourself. Refer instead to professional
companies.
When carrying out any work, make sure that no foreign bodies enter the housing!
When replacing the gobos, make sure that the gobos are inserted correctly into the
corresponding gobo holder. Otherwise, heat damage to the gobos and gobo holders
may occur!
In order to maintain the seal of the AZOR SP2 IP moving head according to protection class IP65,
a new seal must be inserted at the corresponding location after replacing a gobo. Carefully follow
each step in the instructions below. After mounting the cover, perform a leak test.
26