Pkm F7-2S Bedienungsanleitung Seite 146

❖ The safety water supply hose is a double-walled hose. The safety system blocks
the flow of water if the supply hose breaks and water flows into the space between
the supply hose and the outer corrugated hose.
❖ Connect the cold-water inlet hose to a
hose is new or was not used for an extended period of time, let the water flow
until it is clear of any contamination.
NOTICE! Otherwise, the water inlet may be blocked and the appliance will
be damaged.
NOTICE! A hose that attaches to a sink spray can burst if it is installed on
the same water line as the dishwasher. If your sink has one, we
recommend to disconnect the hose and to plug the hole.
NOTICE! After the installation of the water supply and wastewater disposal
as well as before the first operation, all water hose connections – even on
the appliance itself – must be checked for leakage. The manufacturer is
not liable for any damage caused by improper installation.
H
1. Turn off the water supply completely (close water tap).
2. Decrease the water pressure by pressing the pressure reduction button to protect
you and the room from spilled water.
3. Finally remove the water supply hose from the tap.
Depending on model.
37
S
AFETY WATER SUPPLY HOSE
H
OW TO CONNECT THE WATER SUPPLY HOSE
Pull the complete water supply hose out of its
1
storage compartment at the back of the appliance.
Fix the water supply hose with the
2
thread on the tap.
Open the water supply completely before you
3
operate the appliance.
OW TO DISCONNECT THE WATER SUPPLY HOSE
¾
inches thread. When the water supply
~ ~
95
37
¾
inches