Pkm F7-2S Bedienungsanleitung Seite 721

4.2 Carbon filter(s)
Conventional carbon filters cannot be cleaned. The capacity of these filters is
limited. You can use such filters for about 3-6 months. Replace a depleted filter.
Find further information on the filter packaging.
4.3 Replacing of the illuminant
WARNING! The LED illuminant must be replaced by a competent
person only. Do not carry out the replacement of the illuminant yourself.
If the LED illuminant is damaged, please contact a qualified
professional (electrical engineer): not covered by the guarantee.
WARNING! Switch off the appliance and disconnect it from the mains
before you replace the illuminant (use the relevant fuse in your
household fuse box).
NOTICE! Do not touch the illuminant with your hands. The sweat on your
fingers will reduce the operating time of your new illuminant. Use a thin
cloth or a thin glove.
I
NSTRUCTIONS FOR THE QUALIFIED PROFESSIONAL
1. The LED illuminant should have cooled down before you remove it.
2. Open the extractor hood and remove the aluminium grease filter (s. chapter 6.1
C
LEANING OF THE GREASE FILTERS
3. Locate the junction box (A). Unscrew and remove the cover (B) of the junction
box (s. figure below).
If the junction box has a securing plate (C) that presses down the illuminant
connection cable to hold it in position, the securing plate must also be
uninstalled (s. fig. below).
(
ELECTRICAL ENGINEER
).
63
)