Standard Radios Without Ethernet Data Expansion Head; Installing Trunnion; Figure 49: Terminal Into High Profile Trunnion (Gln7317_) - Motorola MTM800 FuG Installationshandbuch

4.6.13

Standard Radios without Ethernet Data Expansion Head

For standard mobile terminals without an Ethernet Data Expansion Head, the jumper between pins 6
and 15 of the junction box (connector 5) should be removed.
Mobile Terminal
With Ethernet Data Expansion
Head
Without Ethernet Data Expan-
sion Head
4.7

Installing Trunnion

When and where to use: The trunnion allows the terminal to be mounted to various surfaces. The
trunnion must be securely fixed to the vehicle chassis.
Procedure:
1 Ensure that the surface can support the weight of the terminal.
Although the trunnion can be mounted to a plastic dashboard, it is recommended that the
mounting screws be located so they penetrate the supporting metal frame of the dashboard.
2 Ground the radio housing to the nearest vehicle chassis ground point, which can be done by
removing the paint from the trunnion where the radio and vehicle chassis touches the trunnion,
or use a short cable with ring lugs in both end and connect this to chassis under the wing screw.

Figure 49: Terminal into High Profile Trunnion (GLN7317_)

Number Description
1 Wing screws (0302637Y01), wing screws are included in Trunnion Mount Kit.
2 Trunnion — main part, Part Number. GLN7317_
Send Feedback
Fit Jumper Pins 6-15?
Yes
No
1
Chapter 4: Radio Installation
Use Junction Box RS232 PEI?
No. Use the Ethernet Data Expan-
sion Head 9-pin PEI instead.
Yes
1
2
68015000553-KC
85