Motorola MTM800 FuG Installationshandbuch Seite 71

Number Description
4 Fuse block
5 Battery
6 Fused power cable (GKN6270_), 3m fuse 10A
7 Transceiver
8 Loudspeaker
9 Fist microphone
10 Accessory Expansion Cable (PMKN4029_)
11 Motorcycle box
12 Antenna
Procedure:
1 The recommended place for the transceiver is to place it in the box at the back of the
motorcycle.
2 Mount the Motorcycle Mount Enhanced Control Head horizontally at a position which enables
the driver to view the controls and operate them easily.
3 Be sure that the Motorcycle Mount Enhanced Control Head is close enough to the vehicle
operator to permit easy access to operating controls.
4 Mount the Motorcycle Mount Enhanced Control Head directly on the chassis or handle part.
5 Ensure that the units mounted in the motorcycle box are protected from dirt and moisture.
6 Verify that there is sufficient space around the units to allow air flow and removal.
7 Verify that the cable from the handlebars-mounted Motorcycle Mount Enhanced Control Head
and to the radio unit is long enough to allow for the handles to be turned.
8 Verify that the antenna cable is routed in the shortest way to minimize power loss over the cable.
9 Check that the mounting surfaces are able to support the weight of the units.
NOTICE: If an additional GPS antenna or a combined TETRA/GPS antenna is used, the
antenna housing carries the GPS/GNSS receiver. Take care not to cover the antenna
housing with metal or other radio wave absorbing material.
10 Slide the Motorcycle Mount Enhanced Control Head onto the mounting trunnion until it snaps
into place.
11 Tighten the screws at both sides of the trunnion. After a few turns, tilt the Motorcycle Mount
Enhanced Control Head for an optimum view of the display. Then, complete the tightening of the
screws.
12 There are two ways to mount the motorcycle trunnion, each limited to a 77 ° of allowable
movement, as shown in the following picture.
Send Feedback
68015000553-KC
Chapter 4: Radio Installation
71