Honda FG110 Benutzerhandbuch Seite 9

Engine Oil Change
Drain the used oil while the engine is warm. Warm oil drains quickly
and completely.
1. Place a suitable container below the engine to catch the used oil.
2. Remove the oil filler cap/dipstick.
3. Tip the motor hoe to drain the used oil through the oil filler opening.
Allow the used oil to drain completely.
Please dispose of used motor oil in a manner that is compatible
with the environment. We suggest you take used oil in a sealed
container to your local recycling center or service station for
reclamation. Do not throw it in the trash, pour it on the ground, or
pour it down a drain.
4. With the engine resting on the carrying handlebar on a level
surface, fill with the recommended oil to the edge of the oil filler
hole. Do not overfill.
Refill amount: 80 cm³
5. Screw in the filler cap/dipstick securely.
Engine Oil Recommendations
Check the engine oil level with the engine stopped and the motor hoe
on a level surface.
Use 4-stroke motor oil that meets or exceeds the requirements for API
service category SJ or later. Always check the API SERVICE label on
the oil container to be sure it includes the letters SJ or later.
SAE 10W-30 is recommended for
general use (see table).
NOTICE
• Running the engine with a low oil
level can cause engine damage.
• Using nondetergent oil can
shorten the engine's service life, and using 2-stroke oil can damage
the engine.
AMBIENT TEMPERATURE
ENGLISH
Air Filter Check
1. Move the choke
lever [1] to the
CLOSED ()
[1]
position to prevent
dirt from entering
the engine.
2. Squeeze together
the air cleaner
upper tab [3] at the
top of the air
cleaner cover [5] to
release it from its
catch, and then flip
the cover down to
remove it.
[6]
3. Check the air filter
[6] to be sure it is
clean, properly
oiled, and in good
condition.
4. If the air filter is dirty, clean it as described under Air Filter
Cleaning. Replace the air filter if it is damaged.
NOTICE
Operating the engine without an air filter, or with a damaged air
filter, will allow dirt to enter the engine, causing rapid engine wear.
This type of damage is not covered under warranty.
5. Align the air filter [6] with
the air cleaner base [2] as
shown. Reinstall the air
filter by locating the three
air cleaner base pegs into
the three air filter holes [7].
Slide the air filter over the
pegs until it is flush with
the air cleaner base.
NOTICE
An improperly installed air
filter will allow dirt to enter
the engine, causing rapid
engine wear. Make sure the air filter is properly installed and flush
with the air cleaner base before installing the air cleaner cover.
6. Reinstall the air cleaner cover [5] by hooking the two lower tabs [4]
on the bottom of the cover and snapping the upper tab [3] into
place.
[2]
[3]
[5]
[4]
[7]
9