Parkside Performance PPRMA 40-Li B2 Originalbetriebsanleitung Seite 49

5 . Place the impact protection on the
side ejector . The impact protection
9 ] [
holds the side ejector chute
position .
˜ Charging the batteries
1 . Remove the battery
machine .
2 . Slide the battery
slot of a charger
3 . Plug the charger
4 . Once charging is complete,
disconnect the charger
mains supply .
5 . Pull the battery
.
27 ] [
˜ Inserting/removing the
batteries
The machine can be
operated with two or
with four batteries of the
X 20 V TEAM series from
Parkside . If you are using
two batteries, they must be
placed one above the other
in pairs .
NOTE
If the batteries are not inserted
u
in the correct combination, the
machine cannot be activated
via the button
level indicator
panel and the charge status of the
batteries is not displayed .
in
[ 22 ]
from the
[ 24 ]
into the charging
24 ] [
.
27 ] [
into an outlet .
27 ] [
from the
27 ] [
out of the charger
[ 24 ]
for the charge
on the control
[ 20 ]
Illustration G:
1 . Lift the cover
[ 8 ]
housing .
2 . To insert the batteries
batteries into the machine along the
guide . You will hear them click into
place .
3 . To remove the batteries
machine, press the release button
on the battery and pull the batteries
out .
˜ Switching on and off
The machine can be
operated with two or
with four batteries of the
X 20 V TEAM series from
Parkside . If you are using
two batteries, they must be
placed one above the other
in pairs .
1 . Place the machine on a level surface .
Illustration G:
2 . Lift the cover
[ 8 ]
housing and insert the charged
batteries into the machine along
[ 24 ]
the guides . You will hear them click
into place .
3 . Before switching the machine on,
make sure that it is not touching any
objects .
Illustration H:
4 . Activate the machine by pressing the
charge level indicator button
the control panel .
NOTE
The LEDs on the control panel light
u
up, the machine is activated and
you can now switch it on .
5 . To switch on, press and hold the
release button
[ 29 ]
start lever towards the upper bar
[ 2 ]
.
[ 1 ]
6 . Let go of the release button .
on the machine
, push the
24 ] [
from the
24 ] [
25 ] [
on the machine
on
20 ] [
while pulling the
GB/IE 45