Mounting The Upper Bar; Mounting The Cup Holder (Fig . B); Operation - Parkside Performance Pprma 40-Li B2 Originalbetriebsanleitung

NOTE
The quick release levers
u
engage in the holes on the machine
housing .
˜ Mounting the upper bar
Illustration B:
1 . Insert the two parts of the bar
insulation into the holes on the
[ 28 ]
lower bar from the right and left
[ 14 ]
respectively, see detailed picture .
NOTE
The bar insulation
u
protect against electric shock .
2 . Attach the upper bar
bar on the right and left using the
14 ] [
bolt washers and clamping levers
provided .
NOTE
The control panel
u
upper bar must be on the right in
[ 1 ]
the direction of travel .
3 . Turn the tightening levers
clockwise to fasten .
4 . Lock the tightening levers
pressing them in the direction of the
upper bar . The tightening levers
1 ] [
must rest against the bar in such a
way that tightening can be carried out
with medium force .
If this fails, continue to turn the
tightening lever clockwise, or loosen
it by turning counter clockwise .
5 . Attach cable holder:
Attach the cable holders
right and left of the lower bar
use them to fix the machine cables
.
15 ] [
must
[ 6 ]
serves to
28 ] [
to the lower
1 ] [
4 ] [
- on the
17 ] [ [ 20 ]
[ 4 ]
by
4 ] [
to the
5 ] [
and
14 ] [
˜ Mounting the cup holder
(Fig. B)
Place the cup holder
bar and there are 4 bolts and nuts
[ 1 ]
should be mounted as illustrated on both
sides, put the hexagon bolt through the
cup holder and tube hole and screw up
the nuts and bolts using SW10 spanner .
˜ Operation
WARNING!
m
The machine must only be
u
adjusted when the motor is
switched off and the blade is
stationary. There is a risk of
personal injury.
WARNING! – Disconnect
battery before maintenance .
Switch off the machine, remove the
u
battery and wait for the blade to
24 ] [
come to a stop .
˜ Hooking in/removing the
grass collection bag
Hook in the grass collection bag,
Illustration C:
1 . Hold the grass collection bag
the handle .
[ 13 ]
2 . Lift the impact protection
3 . Hook the grass collection bag
both holders .
4 . Place the impact protection
grass collection bag
Remove the grass collection bag,
Illustration C:
1 . Lift the impact protection
2 . Unhook the grass collection bag
3 . Fold the impact protection
over the machine housing
to the upper
23 ] [
[ 23a ]
by
[ 12 ]
.
7 ] [
into
12 ] [
on the
7 ] [
.
12 ] [
.
[ 7 ]
.
12 ] [
back
[ 7 ]
.
10 ] [
GB/IE 43