Assembly; Folding Out The Lower Bar - Parkside Performance Pprma 40-Li B2 Originalbetriebsanleitung

l) When working on slopes, make
sure you have a secure footing;
always work across the slope,
never up or down, and be
extremely careful when changing
the direction of work. This reduces
the risk of losing control, slipping and
falling, which could lead to injury .
m) Be especially careful when mowing
in reverse or when pulling the
mower towards you. Always pay
attention to the surroundings. This
reduces the risk of tripping while
working .
n) Do not touch blades or other
dangerous parts that are still
moving. This will reduce the risk of
injury from moving parts .
o) Make sure all switches are turned
off and the battery is disconnected
before removing trapped material
or cleaning the mower. Unexpected
operation of the lawn mower can
cause serious injury .
p) Stop the cutting tool if the machine
has to be tilted for transport when
crossing surfaces other than grass
and when transporting the machine to
and from the mowing area .
q) Do not tilt the machine when the
engine is switched on, unless the
machine must be tilted to start . For
this case, the instruction not to tilt
the machine more than absolutely
necessary and to lift only the part
facing away from the operator .
r) Stop the machine and either operate
the locking device or remove
the detachable battery block(s)
or separate battery block(s), as
applicable, and wait for all moving
parts to come to a complete stop .
42 GB/IE
if a foreign object has been hit; in
–
this case, instruction to inspect the
machine for damage and repair it
before restarting and operating it;
if the machine begins to vibrate
–
abnormally; in this case, instruct
to immediately check for damage,
replace or repair damaged parts
and check for and tighten any loose
part(s) .
s) Empty the grass collector before
storing .
t) Replace worn or damaged
components only in sets to maintain
symmetry .
u) Take care when adjusting the
machine to avoid catching fingers
between the moving cutting tool and
fixed parts of the machine.
v) Always allow the machine to cool
down before storing it .
w) Clean and maintain the machine
before storage .
˜ Assembly
Only carry out work that you know
you are capable of .
If in doubt, consult an expert or our
service centre directly .
˜ Folding out the lower bar
Illustration A:
1 . Turn the lower bar
to the back of the machine . Gently
1 ] [
pull the quick release levers
from the lower bar
left or right for both side .
2 . Adjust to the desired height .
Three positions are possible .
3 . Turn the quick release levers
to their original position .
and upper bar
14 ] [
away
6 ] [
and then turn
14 ] [
back
6 ] [