User Selection; Measuring - Silvercrest Gce613 Bedienungs- Und Sicherheitshinweise

This device has two user options with 120 memory spaces each to
enable the separate storage of measurements taken by two different
persons. If the device is used by multiple users, ensure that the correct
user is selected before each measurement:
The device automatically switches off after 60 seconds. The value is
stored for the last user that was selected or used.
58 GB/IE
460437_2401_V3.0_silv_Blutdruckmessgeraet_Content_OS.indd 58 460437_2401_V3.0_silv_Blutdruckmessgeraet_Content_OS.indd 58

User selection

When on the start display, use the function button>
the desired user.

Measuring

Press the START/STOP button
briefly. The start display greets the selected user
start display, you can access all menu points, e.g. user memory.
Press the START/STOP button
cuff inflates automatically. The measurement process starts.
1
The pulse symbol
detected.
To cancel measuring, press the START/STOP button
The measurement results for systolic pressure, diastolic pressure and
pulse will be displayed. The symbol indicating cuff position control
is displayed for the entire duration of the measurement. If the
16
OK
cuff is too loose,
1
ment stops after approx. 15 seconds and the device switches off.
appears if the measurement has not been carried out correctly.
In this case, please refer to the "Troubleshooting" section.
If desired, re-attach the cuff
. All display elements are shown
6
again to start measuring. The
6
is displayed as soon as a pulse has been
13
is displayed. In this case, measure-
after 1 minute.
1
to select
5
or . From this
.
6
29.05.24 10:51 29.05.24 10:51