Hob Burner Control Knobs - ZANKER ZKF 780 Installations & Bedienungsanleitung

Hob burner control knobs

Once the hob has been installed, it is
important to remove any protective
materials, which were put on in the
factory. The manufacturer will not accept
liability, should the above instructions or
any of the other safety instructions
incorporated in this book be ignored.
The symbols on the knobs mean:
= no gas supply
= maximum gas supply
= minimum gas supply
For easier lighting, proceed before putting a
pan on the pan support.
Lighting the burners
To light a burner, turn the relevant knob
anticlockwise to maximum position and push down
the knob to ignite.
After lighting the flame, keep the knob pushed down
for about 5 seconds. This will allow the
"thermocouple" (Fig.1- lett. D) to be heated and the
safety device to be switched off, otherwise the gas
supply would be interrupted. Then, check the flame
is regular and adjust it as required.
If you cannot light the flame even after several attempts,
check the "cap" (Fig.1 - lett. A) and the"crown" (Fig.1
- lett. B) are in the correct position.
In the absence of electricity, ignition can occur without
the electrical device; in this case approach the burner
with a flame, push the relevant knob down and turn it
anti-clockwise until it reaches the "maximum" position.
To switch off burners
To put the flame out, turn the knob to the
symbol ( ).
Triple crown
C
A - Burner cap
B - Burner crown
C - Ignition candle
D - Thermocouple
A
B
D
Fig. 1
5