ZANKER ZKF 780 Installations & Bedienungsanleitung Seite 14

Remplacement of the voltage cable
The connection of the voltage cable to the
appliance's terminal block is of type "Y". This means
that its replacement requires the specific equipment
of a technician. In this case, only cable type
H05V2V2-F T90 must be used. The cable section
must be suitable to the voltage and the working
temperature. The yellow/green earth wire must be
approximately 2 cm. longer than the phase wires (Fig.
4-a).
To open the terminal block and reach the
terminals, proceed as follows:
insert the point of a screwdriver into the visible
protrunding part of the terminal block;
exert a light pressure and lift (Fig. 4-b).
14
Fig. 4-a
Fig. 4-b
Neutral
Earth
(yellow/green))