Cleaning The Hob; Troubleshooting - ZANKER KEV6442FBB Benutzerinformation

• Scratches or dark stains on the surface have no
effect on how the hob operates.
• Use a special cleaner applicable for the surface of
the hob.
• Use a special scraper for the glass.

Cleaning the hob

• Remove immediately: melted plastic, plastic foil,
sugar and food with sugar. If not, the dirt can cause
damage to the hob. Take care to avoid burns. Put

Troubleshooting

Warning! Refer to Safety chapters.
What to do if...
Problem
You cannot activate or operate the
hob.
An acoustic signal sounds and the
hob deactivates.
An acoustic signal sounds when the
hob is deactivated.
The hob deactivates.
Residual heat indicator does not
come on.
Automatic Heat Up function does
not operate.
22
the special scraper on the glass surface at an acute
angle and move the blade on the surface.
• Remove when the hob is sufficiently cool:
limescale rings, water rings, fat stains, shiny metallic
discoloration. Clean the hob with a moist cloth and
non-abrasive detergent. After cleaning, wipe the hob
dry with a soft cloth.
• Remove shiny metallic discoloration: use a
solution of water with vinegar and clean the glass
surface with a moist cloth.
Possible cause
The hob is not connected to an
electrical supply or it is connected
incorrectly.
The fuse is blown.
You touched 2 or more sensor fields
at the same time.
There is water or fat stains on the
control panel.
You put something on one or more
sensor fields.
You put something on the sensor
field .
The zone is not hot because it op-
erated only for a short time.
The zone is hot.
Remedy
Check if the hob is correctly connec-
ted to the electrical supply. Refer to
the connection diagram.
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Activate the hob again and set the
heat setting in less than 10 sec-
onds.
Touch only one sensor field.
Clean the control panel.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
Let the zone become sufficiently
cool.